Excerpt: ...These are six in number usually, body wire, tail wire and one for each leg. The body wire is about one-half longer than from nose to base of tail; tail wire the length of the tail bone and half the body, and each leg wire twice the length of the leg. I have spoken of using a muskrat for an initial attempt as it is of a convenient size to handle and the length of its fur will hide small defects in the anatomy. Most books of instruction select a squirrel for the beginner's victim. It is true it is not as difficult ...
Read More
Excerpt: ...These are six in number usually, body wire, tail wire and one for each leg. The body wire is about one-half longer than from nose to base of tail; tail wire the length of the tail bone and half the body, and each leg wire twice the length of the leg. I have spoken of using a muskrat for an initial attempt as it is of a convenient size to handle and the length of its fur will hide small defects in the anatomy. Most books of instruction select a squirrel for the beginner's victim. It is true it is not as difficult as a hairless Mexican terrier but it is apt to discourage the learner. An opossum will do very well or any long haired animal of about that size. We will first reconstruct a hind leg and if it is a fresh specimen being mounted without a bath in the pickle we can have the opposite leg in the flesh to guide, as to proper proportions. The wire is passed through the cut in the bottom of the foot and along the back of the leg bones where it is secured in about three places by tying with small cord. The end is left projecting three inches beyond the end of the upper leg bone. The muscles and flesh are replaced by winding on tow with stout thread until the approximate size is reached, when the surface is given a thin coating of clay and the leg is drawn back into its skin. The fore legs are in the same manner built to the joint with the shoulder blade. After sharpening the tail wire to a point it is wound with fine tow and thread and coated with clay until it duplicates the bone and flesh removed. This is slipped into the tail sheath with the unwound end projecting into the body and the slit along the lower side of tail sewed up. After making a ring about the diameter of a .22 shell on one end of the body wire place it on your sketch where the hip joint was marked, letting the wire run lengthwise of the body. Another ring similar is made at the shoulder. These form the points of attachment for the legs. The skull, cleaned of flesh and poisoned, ..
Read Less
